Barcode:
857268006530
Description
The Joerns DermaFloat APL control unit, code DFAPL-CU, is the pump for a DermaFloat APL alternating pressure and low air loss mattress. It is sold without the mattress.
What does it do and how does it work?
- Three modes: Autofirm inflates the surface for transfers, Therapy holds a static surface, and Alternating shifts pressure between adjacent air cells.
- Cycle times are 5, 10 or 15 minutes, with eight comfort settings.
- The system delivers up to 40 litres of airflow per minute and low air loss under the mattress cover.
- Autofirm returns to the previous mode after about 12 minutes.
- A panel lockout prevents unintended changes.
Who is it for, and who should choose something else?
- A caregiver replacing a failed pump on an existing DermaFloat APL mattress.
- A person whose care team recommends alternating pressure and low air loss; the clinician decides.
- Someone who needs the mattress as well should choose the DermaFloat APL mattress or the complete system.
Will it fit?
- The pump is 7.5 in wide, 12.25 in high and 5.5 in deep (19 x 31 x 14 cm), and weighs 10 lb (4.5 kg).
- It hangs on the foot of the bed and connects to the DermaFloat APL mattress hose set.
- Plug it into a grounded 120 V outlet that is not controlled by a wall switch.
- CPR is a quick disconnect at the pump; practise it with the care team. See bed rails for the mattress and rail gaps.
Using it day to day
- Hang the pump, connect the hose, then set the mode and comfort level.
- In a power failure a red light flashes and a beep sounds every 2 seconds for up to 20 minutes. An outage of 20 minutes or less restores the previous settings; after a longer one, reset the mode.
- The therapy cells stay inflated for up to 12 hours if the pump stays connected to the mattress.
- Check the rear air filter; hand-wash it in warm soapy water and let it dry.
- Unplug the pump before cleaning, and wipe the case with a mild detergent without flooding it.
What does it work with, and what are its limits?
- It is the pump only: no mattress, bed or sheets are included.
- Use the DermaFloat APL pump with the DermaFloat APL mattress; do not swap it with another Joerns pump.
- Electromechanical parts carry a one year warranty; the mattress carries two years. See the Warranty tab.
- Do not steam clean the pump or immerse it in water.
How does it compare?
- DermaFloat APL mattress: the therapy mattress for this pump.
- DermaFloat APL system: the pump and mattress together.
- Dolphin fluid immersion system: a different Joerns surface and pump.
Frequently asked questions
Does DFAPL-CU include the mattress?
No. This code is the pump; the DermaFloat APL mattress is a separate order.
What happens in a power cut?
An alarm runs for up to 20 minutes, the cells stay up about 12 hours if connected, and a long outage needs the mode reset.
Is this the same pump as the Dolphin?
No. Use the pump made for the DermaFloat APL mattress.
Funding may help: see who may help pay.
Specifications
- Therapy modes
- Autofirm, static Therapy, Alternating
- Cycle time
- 5, 10 or 15 minutes
- Comfort settings
- Eight settings
- Alarms
- Power-fail light and beep, up to 20 minutes
- CPR release
- Quick disconnect at the control unit
- Airflow
- Up to 40 litres per minute on the DermaFloat APL system
- Power failure protection
- Settings restore after an outage up to 20 minutes; cells about 12 hours if connected
- Power supply
- 120 V AC, 60 Hz, 0.6 A
- Pump weight
- 10 lb (4.5 kg)
- Warranty
- Electromechanical parts 1 year; mattress 2 years
- Product type
- Alternating pressure and low air loss control unit
Figures from the manufacturer. Options and seat sizes can change them; we confirm yours before ordering.
Documents
Delivery and service
Delivery and setup
We deliver and set up equipment across Toronto and the GTA, and show you how everything works. Custom and special-order products can take longer; we confirm timing with you before delivery.
Service and repairs
Our technicians service what we sell, at home or in our shop.
Try before you buy
Visit a showroom in Etobicoke or Brampton to try products first, or book a free home assessment.
Warranty
Warranty details
Joerns Healthcare warrants the DermaFloat APL support surface (mattress and control unit) against defects in workmanship and materials under normal and proper use. The warranty covers the original purchaser.
- Mattress: 2 years.
- Cover and electromechanical parts (compressors, valves, circuit boards, hoses and couplers): 1 year.
- Joerns supplies replacement parts, or services or replaces a defective product, at its option.
- Excludes burns, improper chemicals, needle punctures, cuts or abrasions, excessive loads, staining, improper maintenance or cleaning, use against the manual, and unauthorized modification or repair.
Questions about this product?
Talk to our team, try it in a showroom, or book a free home assessment. We help with sizing and funding.
