Description
HealthCraft's Easy Mount L-shaped grab bar, model G125SK30X30F9, is a stainless rail bent to 90 degrees for a shower corner or a tub end. Each leg runs 30 in (76.2 cm) between flange centres, and the knurled grip helps wet hands hold on.
Will it fit your wall?
Each flange carries nine screw holes instead of the usual three, which helps when your studs are not where a plain bar wants them.
It still has to reach solid framing: the maker says this bar goes straight into studs, so a hollow-wall anchor will not fit and metal studs are out. Send a photo of the wall through contact us and we will say if blocking is needed.
Where does it go?
An L-shaped bar suits a corner: one leg vertical, the other horizontal along the back wall. The maker gives the recommended height for a horizontal bar as 33 in to 36 in (83.8 cm to 91.4 cm) above the floor.
Length is between flange centres, so allow a little more than 30 in (76.2 cm) of wall each way. Other sizes sit under bathroom safety.
How do you install it?
Eight stainless wood screws come in the box, and the flange covers slide off so you can mark the holes. Level the bar, drill pilot holes, then drive at least two screws through each flange.
Slide the covers back on and check the screws monthly, tightening any loose ones. Our service team can fit it if you would rather not.
What are the limits?
The maker rates this bar at 500 lbs (227 kg) of user weight on a sound wall. It is a steadying rail, not a hoist: the maker states it is not meant to carry full body weight, and it is for indoor use only.
Funding help for a bathroom rail in Ontario
Funding may help: see who may help pay. Bathroom rails are bought privately in most cases.
Delivery and returns
We deliver across Toronto and the GTA. Once the bar is fixed to a wall it cannot be returned, under our return policy.
Frequently asked questions
Where does an L-shaped bar work best?
In a corner, one leg vertical and the other along the back wall.
Can it go on drywall alone?
No. The maker says this bar has to reach wall studs.
How do I clean a stainless grab bar?
Warm water and mild soap. No abrasive or corrosive cleaners.
Does it need checking after it is fitted?
Yes. The maker asks for a monthly check of the screws.
Is the knurled grip hard on the hands?
It is a textured surface, made for a firmer hold with wet hands.
Specifications
- Weight capacity
- 500 lbs (227 kg) of user weight
- Assembly
- Eight stainless wood screws supplied, with pilot holes, a level and sealant needed
- Overall length
- 30" x 30" (76.2 cm x 76.2 cm) between flange centres, at a 90 degree angle
- Uses
- A steadying rail beside the toilet, in the shower and over the tub
- Water resistance
- Built for wet bathrooms, and not intended for outdoor use
- Material
- #304 stainless steel
- Mounting
- Nine-hole Easy Mount flanges, screwed directly into wall studs
- Bar diameter
- 1.25" (32 mm)
- Finish
- Knurled stainless steel
- Warranty
- Limited lifetime
- Product type
- L-shaped grab bar
Figures from the manufacturer. Options and seat sizes can change them; we confirm yours before ordering.
Documents
Delivery and service
Delivery and setup
We deliver and set up equipment across Toronto and the GTA, and show you how everything works. Custom and special-order products can take longer; we confirm timing with you before delivery.
Service and repairs
Our technicians service what we sell, at home or in our shop.
Try before you buy
Visit a showroom in Etobicoke or Brampton to try products first, or book a free home assessment.
Questions about this product?
Talk to our team, try it in a showroom, or book a free home assessment. We help with sizing and funding.
